You can pick it up passively over time, and with your skills, if you were to actively engage then I suspect pick up the necessary very quickly, and the rest comes from experience.
I picked up Linux at 13, fortuitously just in time for the release of the Nokia 770 (later getting, and still owning the N900 too).
At that time, getting real dirty with the kernel, hardware, cross compiling etc was necessary, so 1) there were more resources 2) it was seen as mundane, busy work rather than mystical and difficult.
If I were to say how to learn the same things today, I’d probably say Gentoo is ideal - it’s insanely flexible in tinkering, has good resources on compiling the kernel and packages, and I’m a fan of crossdev for cross compiling.
Getting real dirty with hardware and electronics, the obvious answer would be one of the Raspberry Pi lineup, but if you’re very tenacious, patient and a touch unhinged, then I would actually say now’s the time to get in on RISC-V.
It’s still early days, so there’s lots of resources that have very thin abstractions between hardware <-> tooling <-> code. Devices are cheap and exciting. You’ll be on the same footing as most other people so you won’t feel like a dunce.
The cons are that a lot of RISC-V devices get shipped out with very little documentation (and sometimes only in Chinese), binary blobs making mainstream kernels difficult, and you’re learning at the same time, so you might feel you’re ice skating uphill.
Wrt to the bootloader and partition corruption; towards the twilight years of the life of the N900, when it became clear N900 had been abandoned and the N950 was still only available to select few, a bunch of smart people on the Maemo forums started reversing and writing open drivers (uboot bootloader, wifi, camera iirc), so they became pretty documented.
I picked up Linux at 13, fortuitously just in time for the release of the Nokia 770 (later getting, and still owning the N900 too).
At that time, getting real dirty with the kernel, hardware, cross compiling etc was necessary, so 1) there were more resources 2) it was seen as mundane, busy work rather than mystical and difficult.
If I were to say how to learn the same things today, I’d probably say Gentoo is ideal - it’s insanely flexible in tinkering, has good resources on compiling the kernel and packages, and I’m a fan of crossdev for cross compiling.
Getting real dirty with hardware and electronics, the obvious answer would be one of the Raspberry Pi lineup, but if you’re very tenacious, patient and a touch unhinged, then I would actually say now’s the time to get in on RISC-V.
It’s still early days, so there’s lots of resources that have very thin abstractions between hardware <-> tooling <-> code. Devices are cheap and exciting. You’ll be on the same footing as most other people so you won’t feel like a dunce.
The cons are that a lot of RISC-V devices get shipped out with very little documentation (and sometimes only in Chinese), binary blobs making mainstream kernels difficult, and you’re learning at the same time, so you might feel you’re ice skating uphill.
Wrt to the bootloader and partition corruption; towards the twilight years of the life of the N900, when it became clear N900 had been abandoned and the N950 was still only available to select few, a bunch of smart people on the Maemo forums started reversing and writing open drivers (uboot bootloader, wifi, camera iirc), so they became pretty documented.