Thanks!
> To protect the ultrasonic mister from bad firmware frying it, you could probably replace R6 with a sufficiently sized capacitor to make an effective DC block
That is an excellent idea - I'll definitely keep that in mind for a future version.
> I've also had issues with a thermal sensor just reading board temp, best solution is to make the sensor a separate board. Short of that, one can mill slots around it and reduce copper pour to reduce thermal conductivety from the PCB.
I ended up just moving the sensor offboard and as far away from the heat source as I reasonably could. I did consider the milled slots + reduced pour option, but given the amount of heat generated by the LEDs, it seemed best to move the sensor further away.
Addressing some of the comments/concerns in your documentation:
* To protect the ultrasonic mister from bad firmware frying it, you could probably replace R6 with a sufficiently sized capacitor to make an effective DC block
* I've also had issues with a thermal sensor just reading board temp, best solution is to make the sensor a separate board. Short of that, one can mill slots around it and reduce copper pour to reduce thermal conductivety from the PCB.