Profit is dependent on scale. FPGAs are useful if the scale is so small that an ASIC production line is more expensive than buying a couple of FPGAs.
If the scale is large enough that ASIC production is cheaper, you reap the performance improvements.
Think of it this way: FPGAs are programmed using ASIC circuitry. If you programmed an FPGA using an FPGA (using ASIC circuitry), do you think you'll achieve the same performance as the underlying FPGA? Of course not (assuming you're not cheating with some "identity" compilation). Same thing applies with any other ASIC.
Each layer of FPGA abstraction incurs a cost: more silicon/circuitry/resistance/heat/energy and lower clock speeds.
I'll admit I'm not familiar with the processing requirements of basestations, but the prospect of mass-produced FPGA baseband hardware still seems dubious to me, and I can't find conclusive evidence it being used, only suggestions that it might be useful (going back at least 20 years). Feel free to share more info.
[0] ASIC vs FPGA comparison of RISC-V processor, showing an 18x slowdown (or 94.[4]% reduction), apparently consistent with the "general design performance gap": https://iugrc.journals.ekb.eg/article_302717_7bac60ca6ef9fb9...